FAQ O-HT-3A

Solutions may help you:

1. If the timer dial is not set to ON position, turn the dial to ON position.

2. If low battery indicator flashes, replace with new batteries.

3. If rain delay is on, turn the dial to OFF and back to ON to cancel rain delay.

4. If CLOCK, START TIME, HOW LONG, HOW OFTEN are set incorrectly, turn the dial to each position and ensure all setups are correct.

Solutions may help you:

1. If the filter is blocking by dirt or stones, clean the filter or replace it with a new one.

2. If hose connection is cross-thread, ensure the timer is installed properly and not cross-threaded.

3. If inlet pressure is sufficient is not sufficient to support watering needs, install a booster pressurizing equipment.

Note: This timer is built with a solenoid valve. Technically, all solenoid valves decrease water pressure. If you are not satisfied with the decreased water pressure, please contact us directly for more details about ball-valve timers.

Solutions may help you:

1. If the timer dial is at Off position, turn the dial to ON position.

2. If low battery indicator flashes, replace with new batteries.

3. If hose faucet is off, turn on the faucet.

4. If the diaphragm inside the built-in solenoid valve is stuck, reset the solenoid valve. Step 1: Attach the timer on your faucet and open the faucet to max. Step 2: Manually turn the timer on for more than 5 seconds and then turn it off. Repeat above steps for more than 5 times until water flows through the valve smoothly.

Solutions may help you:

1. If manual watering is on, turn the dial to OFF and back to ON to cancel manual watering.

2. If impurities, like stones or hairs, are stuck in the solenoid valve, reset the solenoid valve. Step 1: Attach the timer on your faucet and open the faucet to max. Step 2: Manually turn the timer on for more than 5 seconds and then turn it off. Repeat above steps for more than 5 times until water flows the valve smoothly.

Solutions may help you:

1. If filter washer lost or damaged, ensure the filter washer is clean and undamaged.

2. If the faucet is installed incorrectly, ensure the faucet or hose are 3/4"NH thread while all connections are hand tight and not cross-threaded.

3. If water pressure is too high, ensure water pressure within the range of 8-120PSI (0.5-8.0Bar).

Solutions may help you:

1. Air condenses inside the screen due to the temperature difference between inside and outside. ---> The fog will disappear when the temperature rises, or leave it stand for a period of time.

2. If the battery is dead or is installed improperly, replace with new batteries. Remember to keep your hands dry when install batteries.

3. If LCD is broken or detective, contact the customer service for a new replacement.