FAQ O-HT-1BW

Solutions may help you:

1. If you cannot turn P1/P2/P3 off, keep pressing "-" button at WATER DAY setup of P1/P2/P3 until OFF display.

2. If the timer dial is not set to ON position, turn the dial to ON position.

3. If the battery power is low, replace with new batteries.

4. If rain delay is on, long press DELAY button (3 secs) with the dial at AUTO to cancel rain delay.

5. If CLOCK, START TIME, HOW LONG, HOW OFTEN are set incorrectly, turn the dial to each position and make sure all setups are correct.

Solutions may help you:

1. If the filter is blocking by dirt or stones, clean the filter or replace it with a new one.

2. If the hose connection is cross-threaded, ensure the timer is installed properly and not cross-threaded.

3. If the inlet pressure is not sufficient to support watering needs, install a booster pump or other booster pressurizing equipment.

Solutions may help you:

1. If the timer dial is at OFF position, turn the dial to ON position.

2. If battery power is low, replace with new batteries.

3. If hose faucet is off, turn on the faucet.

4. If the diaphragm inside the built-in solenoid valve is stuck, follow the steps to reset the solenoid valve: Step 1: Turn the dial to OFF. Step 2: Simultaneously press "OK" and "-" buttons for 3 seconds, the timer enters into reset mode. Step 3: During reset mode, the valve open and close repeatedly. Step 4: Once water flows through smoothly, simultaneously press "OK" and "-" buttons for 3 seconds again, the the timer will cancel reset mode.

Solutions may help you:

1. If manual watering is on, turn the dial to OFF and back to ON to cancel manual watering.

2. If impurities, like stones or hairs, are stuck in the solenoid valve, follow the steps to reset the solenoid valve: Step 1: Turn the dial to OFF. Step 2: Simultaneous press "OK" and "-" buttons for 3 seconds, the timer enters into reset mode. Step 3: During reset mode, the valve open and close repeatedly. Step 4: Once water flows through smoothly, simultaneously press "OK" and "-" buttons for 3 seconds again, then the timer will cancel reset mode.

Solutions may help you:

1. If the filter washer is miry, ensure the filter washer is clean and undamaged.

2. If the faucet installed incorrectly, ensure the faucet or hose are 3/4" NH thread while all connections are hand tight and not cross-threaded.

3.If the water pressure is too high, ensure water pressure within the range of 8-120PSI (0.5-8.0Bar).

Solutions may help you:

1. Air condenses inside the screen due to the temperature difference between inside and outside.--->The fog will disappear when the temperature rises, or leave it stand for a period of time.

2. If the battery is dead or installed incorrectly, replace with new batteries. Remember to keep your hands dry when installing batteries.

3. If the LCD screen is broken or defective, contact the customer service for a new replacement.